6
Turn the shaver on and pour a small
amount of water over the outer foil.
After about 10-20 seconds, turn the
shaver off.
Remove the foil frame and rince it
under tap water.
Wipe off any moisture from the
shaver with a dry cloth and remove
the protective cap to allow the outer
foil to dry completely.
Brush cleaning
Squeeze the foil frame release but-
ton and lift the foil frame upwards to
remove it. Remove the inner blade
by grasping it firmly at both ends and
pulling it straight away from the
shaver. Clean the outer foil, the
shaver body with the long side of the
brush. Clean the inner blade with the
short side of the brush. Do not use
the short brush to clean the outer foil.
Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year and
the inner blade at least every two
years to maintain your shaver’s cut-
ting performance.
Remove the outer foil
(see fig. 5)
Squeeze the foil frame release but-
ton and lift the foil frame upward to
remove it. Remove the outer foil from
the frame by slipping it off the hooks.
(Caution: The foil may spring out
when released from the hooks.)
Insert the new outer foil
Slip the foil into the frame with the
plastic edges facing inward. Guide
the plastic edges onto the hooks in
the frame.
Replacing the inner blade
(see fig. 6)
Squeeze the foil frame release but-
ton and lift the foil frame upward to
remove it. Remove the inner blade
by grasping it firmly at both ends and
pulling straight away from the shaver.
To insert the new inner blade, hold
the blade at both ends and press
downward until it snaps into the
shaver.
Caution
• Do not leave the appliance in
places where it will be exposed to
high temperature or direct contact
with sunlight.
• Do not leave the shaver in direct
sunlight to dry with the outer foil
removed.
• The outer foil is very thin. If han-
dled improperly, it can be easily
damaged. To avoid personal injury,
do not use the shaver if it has a
damaged foil or inner blade.
• Wash the shaver with tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
that are designed for toilets, bath-
rooms or kitchen appliances. Do not
submerge the shaver in the water
for a long time.
• Do not wipe any part of the shaver
with thinner, benzine or alcohol.
Clean it by using a cloth dampened
with soapy water.
• Do not take the housing apart as
this can affect the watertight con-
struction.
• If the shaver is not used for a long
time, remove the batteries to pre-
vent possible leakage.
• If the shaver is not working prop-
erly, have it inspected at the place
of purchase or an authorized serv-
ice center.
• Always use your shaver for its in-
tended use, as described in this
7
manual.
This product is intended for house-
hold use only.
P05-29.ES3830(欧州) 04.1.26 23:24 ページ 6
