8-ENGLISH
Lens calibration
Perform lens calibration after attaching the lens.
The lens calibration procedure differs depending on the projector you are using and the
main version of the firmware.
z
PT-SRQ32KC / PT-SRZ31KC / PT-SRS30KC: Main version is 3.00 or later
Refer to "Case 1" (
x
page 8).
z
PT-SRZ21KC / PT-SRS20KC: Main version is 2.00 or later
Refer to "Case 1" (
x
page 8).
z
PT-SRQ13KC / PT-SRZ12KC / PT-SRS11KC / PT-SDZ21K2C / PT-SDS20K2C /
PT-SDW17K2C / PT-SDZ18K2C / PT-SDZ985C / PT-SDS955C /
PT-SDW935C / PT-SDZ981C
Refer to "Case 2" (
x
page 10). (Only ET-D3LEW50C is supported)
■
Case 1
z
PT-SRQ32KC / PT-SRZ31KC / PT-SRS30KC (main version of the firmware is 3.00 or later)
z
PT-SRZ21KC / PT-SRS20KC (main version of the firmware is 2.00 or later)
Attaching the Lens / Detaching the Lens (continued)
1) Press the <
菜单
> button.
2)
Use the ▲ and ▼ buttons to
select [PROJECTOR SETUP],
and press the <
执行
> button.
z
The [PROJECTOR SETUP] screen
appears.
3)
Use the ▲ and ▼ buttons to
select [LENS], and press the
<
执行
> button.
z
The [LENS] screen appears.
1/2
PROJECTOR SETUP
PROJECTOR ID
ALL
PROJECTION METHOD
LENS
OPERATION SETTING
NORMAL
LIGHT OUTPUT
100.0%
BRIGHTNESS CONTROL
AUTO
STANDBY MODE
NORMAL
NO SIGNAL SHUT-OFF
DISABLE
NO SIGNAL LIGHTS-OUT
DISABLE
INITIAL STARTUP
LAST MEMORY
STARTUP INPUT SELECT
LAST USED
DATE AND TIME
SUB MENU
MENU SELECT
执行
4)
Use the ▲ and ▼ buttons to
select [LENS CALIBRATION],
and press the <
执行
> button.
z
The [LENS CALIBRATION] screen
appears.
z
When the ET-D3LEW50C is
attached, a confirmation screen
appears when the <
执行
> button is
pressed. In such cases, proceed to
step 6.
SUB MENU
MENU SELECT
LENS
LENS TYPE
ET-D3LEW60C
LENS INFORMATION SETTING
LENS MEMORY
LENS HOME POSITION
ACTIVE FOCUS OPTIMIZER
LENS CALIBRATION
执行
