background image

Lamp unit for DLP

TM

Projector  Commercial Use

Replacement Instructions

Read these instructions completely before replacing Lamp unit.

Model No.

ET-LAD40 

(1 pc.)

ET-LAD40W 

(2 pcs.)

WARNING!

When  replacing  the  lamp,  allow  it
to cool for at least one hour before
handling it.

NOTICE:

For USA only
Hg -LAMP CONTAINS MERCURY,
Manage in Accord with Disposal Laws,
See: www.lamprecycle.org or 1-888-411-1996

WARNING!

Make  sure  that  two  lamp  units  are
always installed.

Information for Users on Collection and Disposal of Old Equipment and used Batteries

Cd

These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic

products and batteries should not be mixed with general household waste. 

For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection

points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. 

By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential

negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. 

For more information about collection and recycling of old products and batteries, please contact your local municipality,

your waste disposal service or the point of sale where you purchased the items.

Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.

For business users in the European Union

If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. 

[Information on Disposal in other Countries outside the European Union]

These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities

or dealer and ask for the correct method of disposal.

Note for the battery symbol (bottom two symbol examples): 

This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the

Directive for the chemical involved. 

TQZH920-5

Summary of Contents for ET-LAD40

Page 1: ...e products and batteries correctly you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling For more information about collection and recycling of old products and batteries please contact your local municipality your waste disposal service or the point of sale where you pur...

Page 2: ... necessary The replacement guideline is 3 000 hours although the lamp may become dead will not light before 3 000 hours is reached depending on the characteristics of individual lamps and other factors such as the operating conditions and the installation environment Therefore it is recommended for the user to keep a spare lamp unit The risk of the lamp bursting increases after 3 000 hours of oper...

Page 3: ...ove the lamp units Install the new lamp unit Use a Phillips screwdriver to securely tighten the 2 lamp unit fixing screws two for each unit Lamp unit 2 Handle Lamp unit 1 Lamp unit Fixing screws Secure the two screws for securing the fan unit tightly Slide the cover a little toward the right and secure it using the screw for securing the lamp unit cover tightly Firmly install the lamp unit and lam...

Page 4: ... the air filter in the reverse order to step Install the air filter into place with the filter material facing the back The air filter must be installed in place when using the projector Using the projector without the air filter installed inside dirt and dust are sucked into the projector causing failure Clean the air filter section once every 100 hours or so as a guideline depending on the locat...

Reviews: