J
Notes on replacing the lamp unit
•
The light source lamp is a glass component. If it is hit on a hard object or dropped,
breakage may occur. Be careful when handling a light source lamp.
•
A Phillips screwdriver is necessary when replacing the lamp unit. Hold the screwdriver
firmly.
• Grip the handle when you remove the lamp unit. Some parts of the lamp unit are
sharpened and may cause injury.
• The lamp contains mercury. Contact the local government office or distributor for the
correct disposal of the old lamp unit.
•
If you continue to use a lamp after the replacement time, the lamp may break.
•
Do not disassemble the lamp unit.
•
When replacing the lamp because it has stopped illuminating, there is a possibility that
the lamp may be broken. If replacing the lamp of a projector which has been installed
on the ceiling, you should always assume that the lamp is broken, and you should
stand to the side of the lamp cover, not underneath it. Remove the lamp cover gently.
Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass
get into your eyes or mouth, seek medical advice immediately.
LAMP NO. : ET-LAE200
E-8
