ENGLISH
- 7
Illustrations in these operating instructions
z
Illustrations of the projector, screen, and other parts may vary from the actual product.
Term
z
In this manual, the "Wireless remote control unit" accessory of the projector is preferred as the
"Remote control".
Attention
z
The light source lamp is a glass component. If it is hit on a hard object or dropped, breakage
may occur.
Be careful when handling a light source lamp.
z
Grip the handle when you remove the lamp unit. Some parts of the lamp unit are sharpened and
may cause injury.
z
Do not disassemble or modify the lamp unit.
z
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp
may be broken. If replacing the lamp of a projector which has been installed on the ceiling, you
should always assume that the lamp is broken, and you should stand to the side of the lamp
cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when
the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice
immediately.
z
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
Panasonic Connect Co., Ltd. takes no responsibility for any damage or malfunction of the
product resulting from use of lamp units which are not manufactured by Panasonic Connect Co.,
Ltd. Use only specified lamp units.
z
Do not loosen other than designated screws.
z
Be sure to reset the lamp counter after replacing the lamp unit.
Note
z
A Phillips screwdriver is necessary when carrying out replacement.
Hold the screwdriver firmly.
Replacing the Lamp unit
