8
- ENGLISH
Installation (continued)
Attaching the projector drop-prevention kit
Install the wire rope to the projector (sold separately).
A
A
As shown in the figure on the left, secure the one end
(round crimping terminal) of the supplied wire rope to
the A on the projector by using the 1 supplied captive
washer screw (M4 x 12).
Attention
z
Be sure to use the supplied wire rope.
Note
z
Use the supplied flat washers while installing the wire
rope to the ceiling.
z
The position of A may vary with the model. For the
information of the position of installing the wire rope,
refer to the Operating Instructions of the projector.
Note
z
For information on how to join this product to the ceiling mount bracket (for low ceilings) (separately sold) or the
ceiling mount bracket (for high ceilings) (separately sold) and how to attach the wire rope in the ceiling, refer to
the installation instructions or other instructions supplied with the ceiling mount bracket (for low ceilings) or the
ceiling mount bracket (for high ceilings).
Wire rope
Wire rope
Screw, captive
washer
