4
- ENGLISH
Product description
This is a projector mount bracket for installing projectors.
■
Applicable ceiling mount brackets
ET-PKL100S (for low ceilings) / ET-PKL100H (for high ceilings)
Note
z
In this document, the alphabet letters at the end of the projector part numbers are omitted.
■
Structural components
Parts name
Form (number of parts)
Applications
Projector mount
bracket
× 1
This is used to install the projector
itself.
It has a function which allows
adjustment of the left and right tilt.
Screws
Screw, captive washer (M4×10)
These are used to secure the
brackets to the projector.
× 4
Projector drop-
prevention kit
Screw, captive washer (M4×12)
Prevents the projector from falling.
× 1
Wire rope
[2.0 mm (3/32") wire diameter, 600 mm (23-5/8") length]
× 1
× 1
Wire rope for projector
Screw, captive
washer (M4×12)
Flat washer
(M8)
[2.0 mm (1/8") wire diameter,
600 mm (1´11) length]
× 1
× 1
Flat washer
× 1
z
Store small parts in an appropriate manner, and keep them away from children.
z
Tightening torque for the screw is M4: 1.25 ± 0.2 N•m.
z
When tightening up the screws, use a tool such as a torque screwdriver. Do not use electric screwdrivers or
impact screwdrivers.
Attention
z
Dispose of the packaging materials properly after taking the product out of it.
Note
z
The projector models listed below require three of the four supplied captive washer screws (M4 × 10) for
installation.
Model: PT-VW355N, PT-VW350, PT-VX425N, PT-VX420, PT-VX421; PT-VW360, PT-VX430, PT-VX431K
