Panasonic EY0005, Operating Instructions Manual

NOTE:

• When charging a cool battery pack 

(below 5

°

C (41

°

F)) in a warm place, 

Ieave the battery pack at the place 
and wait for more than one hour to 
warm up the battery to the level of the 
ambient temperature.
Otherwise battery pack may not be 
fully charged. 

• Cool down the charger when charging 

more than two battery packs 
consecutively. 

• Do not insert your fingers into contact 

hole, when holding charger or any 
other occasions. 

CAUTION: 

• Do not use power source from an 

engine generator. 

• Do not cover vent holes on the charger. 
• Do not use the battery adapter EY0890 

with battery charger EY0005.

III

.

LAMP INDICATIONS

Red Flashing

Charger is plugged into the AC outlet. 
Ready to charge.
Battery pack is warm. Charging will begin
when temperature of battery pack drops. 
Charging is not possible. Clogged with
dust or malfunction of the battery pack. 

Now charging

Charging is completed.

Red Lit

Red Flashing quickly

Model 
Electrical rating 
Weight

Charging time 

EY0005 

See the rating plate on the bottom of the charger. 

0.70 k

g

,(1.54 lbs.)

7.2 V

1.2 Ah

1.7 Ah

2.0 Ah

9.6 V

12 V

EY9065
EY9066

EY9080
EY9086

EY9180
EY9182

EY9101

EY9001

EY9005, EY9006

EY9106

30min.

45 min.

50 min.

NOTE:

This chart may include models that are not available in your area. 
Please refer to the catalogue. 

CAUTION: • Do not use the battery adapter EY0890 with battery charger EY0005.

• Do not charge other Panasonic battery packs except for the battery packs as 

shown above.

NOTE: 

• When you charge the battery pack for 

the first time, or after prolonged 
storage, charge it for about 24 hours 
to bring the battery up to full capacity. 

1. Plug the charger into the AC outlet. 

NOTE: 

• Sparks may be produced when the 

plug is inserted into the AC power 
supply, but this is not a problem in 
terms of safety.

2. Insert the battery pack firmly into the 

charger. 

3. During charging, the charging lamp will 

be lit. 
When charging is completed, an internal 
electronic switch will automatically be 
triggered to prevent overcharging. 
• Charging will not start if the battery pack 

is too warm (for example, immediately 
after heavy-duty operation). 
The charging lamp will be red flashing 
until the battery cools down. Charging 
will then begin automatically.

4. When charging is completed, the charging 

lamp will start flashing quickly. 

5. If the charging lamp does not light 

immediately after the charger is plugged 
in, or if after the standard charging time 
the lamp does not go off, consult an 
authorized dealer. 

CHARGING THE
BATTERY

II

.

Battery pack

To AC
outlet

Battery charger

—

 4 

—

—

 5 

—

SPECIFICATIONS

IV

.

EY0005̲EU.qxd  04.11.18 14:00  ページ 5