Ref.No.2D
Procedure 2A
→
→
→
→
2B
→
→
→
→
2C
→
→
→
→
2D
Assembly of the Adjusting Screw and the Clutch
Handle.
1. Align the
mark of adjusting screw with the center of upper
projection of clutch case.
2.Turn the adjusting screw into the driving block about one rotation
for clockwise direction.
3. Align the
mark of adjusting screw with the center of
upper projection of clutch case.
4. Set the clutch handle with position 1 on top.
5. Insert the clutch handle with adjusting the tabs of adjusting
screw to the groove of inside clutch handle.
Fig.11
6
EY6405-X8 / EY6409-X8 / EY6432-X8
