—
4
—
III. FOR
BATTERY CHARGER &
BATTERY PACK
1)
SAVE THESE IN-
STRUCTIONS
-This
manual contains important safety and
operating instructions for battery
charger EY0230.
2) Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack.
3)
CAUTION
-To reduce the risk of
injury, charge only Battery Pack shown
below.
EY9001, EY9080, EY9065, EY9066,
EY9006, EY9086, EY9101, EY9180,
EY9182, EY9106, EY9107, EY9136,
EY9168, EY9230, EY9200, EY9201,
EY9231
Other types of batteries may burst caus-
ing personal injury and damage.
4) Do not expose charger to rain or snow.
5) To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6) Make sure cord is located so that it will
not be stepped on, tripped over, or oth-
erwise subjected to damage or stress.
7) An extension cord should not be used
unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric shock.
If extension cord must be used, make
sure:
a. that pins on plug of extension cord
are the same number, size and
shape as those of plug on charger.
b. that extension cord is properly wired
and in good electrical condition.
c. that wire size is large enough for
ampere rating of charger as specified
below.
8) Do not operate charger with damaged
cord or plug—replace them immediately.
9) Do not operate charger if it has received
a sharp blow, been dropped, or other-
wise damaged in any way; take it to a
qualified serviceman.
10) Do not disassemble charger; take it to a
qualified serviceman when service or
repair is required. Incorrect reassembly
may result in a risk of electric shock or
fire.
11) To reduce the risk of electric shock,
unplug charger from outlet before
attempting any maintenance or clean-
ing.
12) The charger and battery pack are spe-
cifically designed to work together. Do
not attempt to charge any other cordless
tool or battery pack with this charger.
13) Do not attempt to charge the battery
pack with any other charger.
14) Do not attempt to disassemble the bat-
tery pack housing.
15) Do not store the tool and battery pack in
locations where the temperature may
reach or exceed 122°F (50°C) (such a
metal tool shed, or a car in the summer),
which can lead to deterioration of the
storage battery.
16) Do not charge battery pack when the
temperature is BELOW 32°F (0°C) or
ABOVE 104°F (40°C). This is very
important.
17) Do not incinerate the battery pack. It can
explode in a fire.
18) Avoid dangerous environment. Do not
use charger in damp or wet locations.
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating.
Amperes
AWG Size of Cord
Equal to or
greater than
But less
than
Length of Cord, Feet
25
50
100 150
0
2
18
18
18
16
