5 TRIAL OPERATION (after checking TROUBLESHOOTING
GUIDE.)
5.1. HAMMER/DRILL
Confirm the action when setting the H/D handle to HAMMER mode.
Rotation with hammering when the drill bit touches something like stone, and power.
It is OK, if it takes about 4-6 seconds by 20kgf to hole (
6X30) on the concrete .
Confirm the action when setting the H/D handle to DRILL mode.
No hammering when the drill bit touches iron plate.
5.2. SWITCH
<SPEED CONTROL>
Change the rotation speed from 0-1000 rpm in proportion to the amount of pushing level on switch trigger.
<LED>
Check if the LED is lits.
5.3. REVERSING LEVER
Confirm the action with setting the reversing lever to FORWARD or REVERSE.
5.4. ASSEMBLY
Confirm pressing the lead wires between ribs, tightening screws firmly.
10
EY6803-X8
