- 6 -
Support handle ... (I)
Place the support handle at your fa-
vorite position and tighten the handle
securely.
Loosen
Tighten
Depth gauge ... (B)
Loosen the support handle and ad-
just the depth gauge at your favorite
depth.
After adjusting, tighten the support
handle and fix depth gauge.
Depth gauge
Depth of drilling
Battery pack ... (H)
For Appropriate use of Battery Pack
·Ni-MH Battery pack EY9210
Charge the battery pack fully before
storage in order to ensure a longer
service life.
·Ni-Cd Battery pack EY9116
Discharge the battery pack empty be-
fore storage in order to ensure a long-
er service life.
The ambient temperature range is be-
tween 0°C (32°F) and 40°C (104°F).
If the battery pack is used when the
battery temperature is below 0°C
(32°F), the tool may fail to function
properly. In that case, charge the bat-
tery until charging is completed for
appropriate functioning of the battery.
Battery pack life
The rechargeable batteries have a lim-
ited life. If operation time becomes ex-
tremely short after recharging, replace
the battery pack with a new one.
NOTE:
Use under extremely hot or
cold conditions will reduce op-
erating capacity per charge.
Battery Recycling
For environmental protection and re-
cycling of materials, be sure that it is
disposed of at an officially assigned lo-
cation, if there is one in your country.
ATTENTION:
Ni-Cd Battery pack EY9116
This appliance contains Nickel-
Cadmium. Battery must be recy-
cled or disposed of properly.
Release lever ... (G)
Battery pack Installation and Re-
moval
-For removal-
Pull the release lever to free the bat-
tery holder.
Battery holder
Release
lever
-For installation-
Fit the battery holder unit it clicks in
position.
Battery charger ... (J)
NOTE:
Charge a new battery pack,
or a battery pack that has not
been used for a prolonged time,
for about 24 hours to bring the
battery up to full charge.
