3 DISASSEMBLY/ASSEMBLY INSTRUCTIONS
Ref. No. 1A
Procedure 1A
Removal and attachment of the Housings.
1. Loosen the belt hook bolt turning it counterclockwise, using a
coin or a flat blade screwdriver.
2. Take out the belt hook.
3. Remove nine housing screws.
4. Open the housing B.
NOTE :
The housing A and B is tightened as the motor mounting base
is joint fitting.
Hold the housing B and take it out vertically.
5. Take out the fixation cover, protectors and anvil block.
(Removal)
NOTE :
When opening the housings, make sure that the main PCB is
on the housing A.
If the main PCB sticks in the housing B and pull it out from the
housing A, the ribbon cable may be defected.
(Attachment)
1. Insert the click spring into the housing A.
NOTE :
Be sure to use the tweezers or the small flat-head screwdriver
when inserting the click spring.
3
EY7270-X8 / EY7271-X8
Summary of Contents for EY7270-X8
Page 2: ...1 SCHEMATIC DIAGRAM 2 WIRING CONNECTION DIAGRAM 2 EY7270 X8 EY7271 X8 ...
Page 9: ...5 CHECK PARTS IDENTIFY PROCEDURE 9 EY7270 X8 EY7271 X8 ...
Page 10: ...6 EXPLODED VIEW REPLACEMENT PARTS LIST 6 1 EY7270 EXPLODED VIEW 10 EY7270 X8 EY7271 X8 ...
Page 12: ...6 3 EY7271 EXPLODED VIEW 12 EY7270 X8 EY7271 X8 ...
