EN
EN
- 11 -
EN
EN
• In order to prevent excessive increased
in temperature, do not operate the tool
continuously without interval after fin-
ishing a battery.
Tightening confirmation lamp
• The tightening confirmation lamp can be
used to check whether tightening has been
completed properly.
See the illustration
8
Tool status
Lamp display
Tightening complete
(Normal clutch operation)
Green
(For approx.
seconds)
• Tightening not complete
• Tightening complete
without fulfilling the set
function conditions
Red
(For approx.
seconds)
The automatic power-
off function has been
activated.
Red
(For approx. 5
minutes)
NOTE
• The tightening configuration lamp will
not turn on in reverse rotation mode.
• The tightening configuration lamp turns
off when the tool restarts an applica-
tion.
The battery indication lamp
See the illustration
9
• The battery indication lamp notifies user on
remaining battery power.
• Battery life varies slightly with ambient tem-
perature and battery characteristics.
Indicator
Battery status
Fully charged
Approx. 40% or less
remaining
Flashing
Flashing
Approx. 0% or less
remaining (indicates need
to recharge battery)
The battery pack will need
to be charged soon.
Flashing
No charge
The battery pack needs to
be charged.
(The tool’s automatic
power-off function will
activate at this stage.)
Automatic power-off function
• The automatic power-off function is designed
to prevent a loss of tightening torque due to
reduced battery voltage. Once it has been
activated, the tool will not operate until the
battery pack has been charged (or replaced
with a fresh unit), even if the trigger is
depressed.
NOTE:
• All 3 bars on the battery indication lamp
will flash when the automatic power-off
function is activated.
• Be sure that the battery pack is fully
charged, otherwise the automatic power-
off function may not activate properly.
• The tool may power off automatically
under heavy work loads.
However the tool will be operational
again after the battery is removed and
reinstalled. The battery must have a
sufficient charge to re-enable the tool.
LED light
See the illustration
9
Press the
button to turn on/off the LED
light.
NOTE:
• The light consumes very little power
and will not significantly affect battery
run time.
• The built-in LED light is designed for
temporary use, and may have less
brightness than a regular traditional
flashlight.
• LED light can be linked to trigger switch
operation by setting with a remote con-
trol. (See page 14.)
Caution
: DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
Summary of Contents for EYFGA1A
Page 149: ... 149 MEMO ...
Page 150: ... 150 MEMO ...
Page 152: ...EN DE FR IT NL ES DA SV NO FI PL TR EY9711FGA101 2014 10 Printed in Japan ...
