- 9 -
NOTE:
• All 3 bars on the battery indication lamp
will flash when the automatic power-off
function is activated.
• When the battery indication lamp begins
flashing, the battery pack should be
charged (or replaced with a fresh unit)
immediately.
• Be sure to fully charge the battery pack
in question after activation of the auto
-
matic power-off function. Failure to do
so may prevent the automatic power-off
function from being properly deactivated.
• The tool may power off automatically
under heavy work loads.
However the tool will be operational
again after the battery is removed and
reinstalled. The battery must have a
sufficient charge to re-enable the tool.
(2) LED light
Pressing the button toggles the LED light on
and off.
The light consumes very little power and will
not significantly affect battery run time.
CAUTION:
•
The built-in LED light is designed to illu
-
minate the small work area temporarily.
•
Do not use it as a substitute for a regu
-
lar
flashlight, since it does not have
enough brightness
.
This tool has the built-in LED light.
Caution
: DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
NOTE:
• LED light can be linked to trigger switch
operation by setting with a remote con
-
trol. (See page 13.)
Tightening Torque Setting
1. Open the shutter with the clutch setting
handle.
Shutter (closed)
Front view of the
main unit
Clutch setting handle
(short side view)
Engage the ribs on the main unit with the
ribs on the clutch setting handle (on the
short side) and turn clockwise.
2. Insert the 3 ribs on clutch setting handle
(on the long side) into the shutter holes.
Make sure to insert the wider rib into big
-
ger hole.
Bigger hole
Wider rib
To set clutch torque, turn the clutch setting
handle clockwise or counterclockwise.
Clutch stage can be set from 1 to 60 stage.
(two full turns)
Decrease torque
Increase torque
Summary of Contents for EYFGA1N
Page 50: ... 50 MEMO ...
Page 51: ... 51 MEMO ...
