Menu
(Enter)
Password
(1011 Enter)
Tools
(Enter)
Learn Tool
(Starts the learn sequence
for the highlighted tool slot)
Learn Open Tool
(Starts the learn sequence
for the first empty tool slot)
Exit Tool
(Returns to the Main Menu)
1. Remove/Replace
Battery, Pull tool
trigger for 2 seconds
2. Successful Learn - the
screen will
automatically returns
to the tool menu and
the box will turn green
3. To learn additional
tools return to the
Learn step above.
4. Exit (Returns to the
Main Menu)
1. Remove/Replace
Battery, Pull tool
trigger for 2 seconds
2. Successful Learn - the
screen will
automatically returns
to the tool menu and
the box will turn green
3. To learn additional
tools return to the
Learn step above.
4. Exit (Returns to the
Main Menu)
Tools - Learn/Learn Open
Main menu - Tools
Learn Tool Menu
Page 7
*In the case a tool can not be learned to a Qualifier, try these steps.
1. Check to see that the tools model or serial number contains an “R” which states it has a wireless card included.
2. Make sure to follow the directions on the screen – remove & replace battery then pull tool trigger and release.
3. Check the serial number to see if the tool was built on or after 15=2015/01=Jan (Ser# XXXXXXX1501XXXX),
if yes the wireless card may be disabled. To re-enable the wireless card, pull the tools trigger “7” times, each
trigger pull should show a bad fastenings (red light turns on). The tool should learn to the Qualifier.
Summary of Contents for EYFR03
Page 1: ...Panasonic...
