TROUBLESHOOTING
故障排除
Possible situation
Please confirm the following
After the product stops operation or when the room is cold,
there may be condensation. This is normal.
Is the tray fit into the interior of the product?
Is the product titled?
Please place the product on the level and stable table or floor.
8
9
The water amount in the
tank is not reduced, and
the product does not
humidify, but the
operation indicator is on.
The humidity does not
increase
There is condensation
inside the tray
Even if there is water in
the tank, the water fill
indicator is still blinking
or lights on
The check indicator is on
Have you applied actions such as shaking, tilting and impacting
onto the product?
Disconnect the power plug, and then reinsert the power plug.
Is the product overturned?
Disconnect the power plug.
Erect the product. (Wipe the water off the precut)
Keep the product idle for half a day.
(Doing this is to dry the product thoroughly in case water
drops into the product.)
Power the product on again, and it will operate.
1
2
3
4
Is the humidifying filter dirty? (P.18~19)
Is the anti-fungus assembly installed properly? (P.19)
Is the tray fit into the interior of the product?
Does the humidity sign indicate “70% or more”?
With “Air volume” set to “Auto”, for example in the “Full Auto”
mode, the product will stop humidifying when display “70% or
more” in order to ensure the applicable humidity.
Is the humidifying filter installed properly? (P.18~19)
When the humidifying is installed incorrectly, the product will
sound abnormally, and not humidify.
Is the room ventilated, or has laid the carpet onto the floor?
If there is floor carpet, the humidity may be difficult to increase
sometimes, depending on the specific ventilation, floor and wall
material.
Is the room size is too large for the product? (P.27)
可能發生的狀況
請確認以下內容
水箱水量不減少
，
且不加濕
，
但運轉指示燈為亮起狀態
加濕過濾網是否髒污？（第
18~19
頁）
水盤有無安裝妥當(安裝直至底部)？
加濕過濾網安裝是否正確？（第
18~19
頁）
安裝不正確時
，
可能會發出異常聲響
，
以及不加濕
。
防霉組件是否安裝正確？（第
19
頁）
濕度指示燈是否顯示“
70%
以上”？
“全自動”運轉等“風量自動”設置下
，
為確保適宜的濕度
，
濕度在
70%
以
上時將停止加濕
。(
室內空氣潔淨時
，
將變為待機狀態
。
)
濕度不增加
是否進行了通風換氣
，
地板上是否鋪有地毯？
鋪有地毯時
，
根據通風狀態
、
地板以及牆壁材質的不同
，
有時濕度可能
難以提升？
請確認產品是否在面積太大的場所使用？
(
第
27
頁
)
水盤內側有結露
停止運轉後以及房間較為寒冷時
，
有可能會發生結露
，
屬正常現象並非異常
。
水箱中有水
，
但加水指示燈
閃爍或亮起
水盤有無安裝妥當(安裝直至底部)？
產品是否傾斜了？
請將產品設置在水平且平穩的檯面或地面上
。
檢查指示燈亮起
產品是否翻倒了？
拔出電源插頭
。
1
2
3
4
扶起產品
。(
擦掉附著的水
)
停置半日以上不使用
。(
倘若內部進水
，
停用半天可以完全晾乾
。
)
再次接通電源
，
開始運轉
。
是否對產品施加搖晃
、
傾斜
、
撞擊等動作
？
拔出電源插頭
，
再重新插上
。
26
