Panasonic F-YAV28H, Operating Instructions Manual

To use Auto during operation

To use Auto during standby

Auto mode

About Auto mode

Intelligently determine the best mode through a variety of smart sensing devices.

In Auto mode, when the humidity reaches the set value, and the PM2.5/PM1.0 and odor reach the green level (indicator level 1), after the 

machine runs for a period of time, Auto mode will Automatically enter standby mode. The Auto indicator will keep flashing to remind the 

consumer that the Auto mode has not yet been exited, and will start again when the humidity is higher than the set level or the PM2.5/PM

1.0 and the odor reach the orange light level. (During standby mode, in order to obtain the latest air quality conditions, the fan will run 
for 3 minutes for every 20 minutes.)

In the Auto mode, the air direction is Auto; if it is in the standby mode, the air direction panel will be turned off.

In Auto mode, the front display will be in the cycle mode; the front display will be turned off if it is in standby mode.

In the Auto mode,                       is forced to start; if it is in standby mode,                       will be turned off.

In the Auto mode, full water reminder ON/OFF can be set.

In the Auto mode, press the "Power Off/On" button to end the Auto mode or switch to other functions.

(Humidity

setting)

(Press to

select)

(Skip this step)

(End Auto)

Press the          button in the standby mode (the Auto indicator 

flashes).

The humidity setting lights up; press the          button to set 

the humidity.

If the humidity is set, wait for about 3 seconds and 

automatically enter the Auto mode.

If no humidity is set, it will be automatically set with the 

factory humidity setting (or the previous humidity setting).

After entering the Auto mode, the Auto indicator will be on, 

and other buttons (except the humidity setting) cannot be 

operated.

To leave the Auto mode, press          to leave Auto mode.

Ř

Ř

Press the          button in the standby mode (the Auto indicator 

flashes).

The humidity setting lights up; press the          button to set 

the humidity.

If the humidity is set, wait for about 3 seconds and 

automatically enter the Auto mode.

If no humidity is set, it will be automatically set with the 

factory humidity setting (or the previous humidity setting).

After entering the Auto mode, the Auto indicator will be on, 

and other buttons (except the humidity setting) cannot be 

operated.

To leave the Auto mode, press          to leave Auto mode.

Ř

Ř

(Press to

select)

(Skip this step)

(End Auto)

(Humidity

setting)

Auto indicator

13

YAV28H