123
Operation Manual
FT1020G3 Rev 2.10.4
23.6
Alert Annunciation (H2/B6)
The
AA
function for alarm points / zones programmed for
A
lert
A
nnunciation (via EBLWin)
is normally enabled via a time channel, e.g. enabled daytime (during working hours) and
disabled night time.
As an alternative, the
AA
function can be continuously enabled (always on).
The
AA
function can be disabled via this menu (H2/B6) i.e. the
AA
function will be turned
off for the alarm points / zones programmed for
A
lert
A
nnunciation although the time
channel is "on" or if they are programmed to be continuously enabled.
The
AA
function will remain off until re-enabled again via this menu.
Action
Text in display
Comments
"Menu"
According to chapter
"Access", see page 42.
Scroll to menu H2.
H2 Disable or re-enable
"
↲
"
B1 Zone or Zone/Address
B2 Output
B3 Output type
B4 Alarm devices
B5 Routing equipment
B6 Alert annunciation function
Escape
menu
Scroll to menu B6.
B6 Alert annunciation function
Alert Annunciation
function can be disabled
via menu B6
"
↲
"
Disable
Alert annunciation
Press "
↲
" to disable,
which will be indicated
with "
√
" and a beep.
The disablement will be
automatically shown in
the Re-enable list
"
↲
"
Disable
Alert annunciation
√
-- Re-enable list --------------------------------------------------
Alert annunciation off
Use the soft key "
|
" to
toggle between
Disable
and
Re-enable
.
"
|
"
Disable ------------------------------------
Alert annunciation
Re-enable list
Alert annunciation
off
Press "
↲
" to re-enable.
Alert annunciation off
will disappear from the
list, indicated with a
beep.
Summary of Contents for Firetracker FT1020G3 CIE
Page 1: ...Operation Manual FT1020G3 Rev 2 10 4 For Software V2 10 4 FT1020G3 FDCIE MA430 March 2023...
Page 2: ...This page has deliberately been left blank...
Page 176: ...176 Operation Manual FT1020G3 Rev 2 10 4 Figure 24 FT1020G3 Standard Block Wiring Diagram...
Page 177: ...177 Operation Manual FT1020G3 Rev 2 10 4 Figure 25 FT1020G3 New 5012 PCB Layout...
