85
Operation Manual
FT1020G3 Rev 2.10.4
To acknowledge the faults shown:
•
Login, according to chapter "Access Levels", page 42.
•
Use
menu H6
(access level 2A) to acknowledge fault, see chapter "FAULT
Acknowledge (H6)", page 146. Menu H6 is a list showing a maximum of 300 faults
(not acknowledged faults and/or acknowledged but not serviced / corrected faults).
•
All faults must be individually acknowledged one by one using the key pad button
,
Use
or
to scroll.
•
When a fault is corrected before it has been acknowledged, the text "Serviced" is
added after the time, still has to be acknowledged to remove from the display.
•
When a fault is corrected / serviced and acknowledged, it will disappear from the
list (H6).
•
When
all
faults have been acknowledged, the output for routing equipment (Fault
TX) will not reset and the LED for
Routing equipment
"Fault TX activated"
remains activated until there are no faults in the system.
•
Whilst faults still not corrected in the system (Acknowledged faults corrected or not
corrected), the LED
Fault / Disablements
"General fault" will be lit and general
fault (and maybe general charger fault) output(s) are activated. The fault relay also
stays energised.
•
Faults, corrected faults and acknowledged faults are shown in the General event
log (menu H4/U6).
FAULT: No reply zone: 123 address: 01
technical number 000025
"...alarm text..."
2021-04-03 15:22
/Serviced
FAULT: No reply zone: 123 address: 03
technical number 000027
"...alarm text..."
2021-04-07 09:25
/Acknowledge
Number of faults in system: 5
Menu
Summary of Contents for Firetracker FT1020G3 CIE
Page 1: ...Operation Manual FT1020G3 Rev 2 10 4 For Software V2 10 4 FT1020G3 FDCIE MA430 March 2023...
Page 2: ...This page has deliberately been left blank...
Page 176: ...176 Operation Manual FT1020G3 Rev 2 10 4 Figure 24 FT1020G3 Standard Block Wiring Diagram...
Page 177: ...177 Operation Manual FT1020G3 Rev 2 10 4 Figure 25 FT1020G3 New 5012 PCB Layout...
