Technical/Programming Manual
FT1020G3 Rev 2.2.1
149
Figure 48 Deviation Tab
Selecting any of the tabs (buttons) shown in
above will open a list of the events
for this tab.
Acknowledges, resets, re-enables individual items in the lists
Acknowledges, resets, re-enables all items in the lists.
22.2.4
Selected loop
To the right of the tree view, the "Selected loop" tab
lists all configured loop unit devices in
that loop
as shown in by default.
COM loop units can be added two ways:
Via the tree view (COM loop pop-up menu) or
Via the "Selected loop" tab. Click on the COM loop unit symbol just under the tab
to add the unit to the list.
To see what the symbols mean, refer to section “COM loop units”, page 51. To edit its
properties, double-click on the device name, the respective dialog boxes will appear. The
"Selected loop" list and the tree view will show the same information.
Figure 49 Selected Loop Tab
22.2.5
Alarm points
To the right of the of the tree view the "Alarm points" tab will be available.
