Technical/Programming Manual
FT1020G3 Rev 2.2.1
182
30
National regulations
When planning a fire alarm installation, national regulations, customer demands, etc. have
to be followed.
FT1020G3 is very flexible with many built-in functions & facilities in the S/W and the PC
program EBLWin. When downloading the S/W and/or the SSD, different settings,
conventions, languages, etc. can be selected to fulfil the national regulations /
requirements.
187
30.1
Conventions
In accordance with the section above, a convention is selected the very first time EBLWin
is opened after the installation. This will be the default convention for every new
installation
188.
Normally the same convention shall be used in all installations thereafter. It
is, however, possible to change the convention in the EBLWin dialog box "EBLWin settings"
as in Figure 59. The conventions that can be selected are listed in the valid EBLWin version
(under menu Tools | Options).
If the Most Recent Unit (MRU) check box is ticked, the MRU file will open when EBLWin is
launched. The default COM port to communicate with the CIE can also be changed to your
PC port available for “EBL512 G3”.
Note:
To change convention, a Level 2 special password is required. Access is via the
menu, Advanced functions | Level 2. Also note that the convention will be changed only
for the open installation.
Figure 59 EBLWin Settings Dialog Box
30.2
Language
The language for the text shown in the FT1020G3 display (alarms, faults, menus, etc.) is
dependent on which binary file (*.bin) has been downloaded (normally in conjunction with
the S/W download).
The binary file (*.bin) for the selected language / convention shall be downloaded via
EBLWin (menu Tools | Download software…).
187
Some of the SSD settings might be a violation to the AS7240.2 or 1670.1-2. If this happens, a "Warning" will be displayed.
188
Depending on convention, different default settings in EBLWin could be valid and also different functions in FT1020G3.
