Operation Manual
FT128 Rev 2.4
99
22 Set Calendar and Clock (H3)
The RTC component has no backup power supply. Normally, date, day of the week and
time only have to be set when the power is turned on the FT128 for the first time. Also, if
FT128 is restarted, the clock must be corrected, so that the "time stamps" for fire alarms,
faults, etc. will be correct.
Note: To exit the menu without making any changes, press Return.
After any restart of the control unit, it is recommended to check / set the date and time in
menu H3.
Action
Text in display
Comments
"Access"
Log on to FT128 as shown
in page 35.
Scroll to menu H3.
Set calendar and clock
ACCEPT? H3
"A"
Date: DD-MM-20YY Time: hh:mm:ss
Weekday:1 (1=Monday, 7=Sunday)
The time shown is the time
when "A" was pressed (in
menu H3).
When required, edit the
date, time and/or weekday.
Press "A". The "clock"
starts again from the date,
time, etc. shown in the
display.
NOTE: Press "Return"
(instead of "A")
to return
to menu H3 if no changes
are required.
DD=Date
MM=Month
YY=Year
hh=hour
mm=minute
ss=second
Settings done
"A"
Date and time was set.
Date: DD-MM-20YY Time: hh:mm:ss Day D
Depending on if “A” or
“Return” is pressed.
Scroll or press "Return".
"Return"
Set calendar and clock
ACCEPT? H3
22.1
Daylight Saving Time
The daylight saving is set via EBLWin in the system properties. When set, the time will be
automatically changed according to AU or NZ convention. The daylight saving time is set
in the firmware as shown below:
Australian convention
: Forward 1 hour the first Sunday in October, 02:00
03:00.
Backward 1 hour the first Sunday in April, 03:00
02:00.
New Zealand convention
: Forward 1 hour the last Sunday in September, 02:00
03:00.
Backward 1 hour the first Sunday in April, 03:00
02:00.
Summary of Contents for Firetracker FT128
