Wiring precautions
● Do not damage the core when stripping off the covering material.
● Do not apply stress to the wires after wiring.
● Do not solder the core. Soldering the core may cause it to disconnect due to vibration.
1.
Strip off the covering material from the wire.
10 mm
2.
Attach the pole terminal to the core part. Do not twist the core when attaching.
3.
After attaching the pole terminal, pressure-weld using the dedicated pole terminal pressure-
welding tool.
4.
After pressure-welding, insert the wire into the product.
After inserting the wire, ensure that the wire does not protrude.
2.2.3 Replacing Wires
Follow the procedure below when replacing wires.
Use the following dedicated tool or an equivalent flat-head screwdriver to remove the wire.
2.2 Wiring to Connector
WUME-FPPUSHIN-01
2-5
ramco Innovations www.ramcoi.com nsales@ramcoi.com Phone 800-280-6933
Summary of Contents for FP7 Series
