background image

English

SUPPLIED ACCESSORIES

UNPACKING

Unpack and carefully remove the unit from carton.

Refer to the Supplied Accessories list to verify that all parts are present.

1

1

1

Installation

instructions

Self-drilling

screw

Warranty

sheet

Part name

Part name

Appearance

Quantity

Grille

4

TM

Flex-Z Fast

bracket

(with 4 

tapping screws

   -ST4.2X20)

1

Appearance

Quantity

FCC Note: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that interference will not occur in 

a particular installation. If this equipment does cause harmful interference to radio or television reception, 

which can be determined by turning this product on and off, the user is encouraged to try to correct the 

interference by one of the following measures:

Warning: This equipment must be installed by qualified person in accordance with the provided installation

instructions; and all applicable codes and standards. Also, any changes or modifications not expressly

approved by the party responsible for compliance could void the user’s authority to operate this equipment.
 DoC Responsible Party:            Panasonic Corporation of North America

                                                   Two Riverfront Plaza, Newark, NJ 07102

 Customer Call Center:            1-866-292-7299
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and (2) this device must accept any interference 

received, including interference that may cause undesired operation.

Risk of Fire: Type IC-Inherently Protected.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect equipment into outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

DESCRIPTION

These products are listed by UL under UL file No. E78414.

These products use a sirocco fan driven by a DC motor powered by an integral transformer. The motor is

designed to have long operating life, high dynamic response, higher speed ranges with saving energy.

The grille covering the fan body is a spring-loaded, quick remove type. A damper for preventing air counter

flow is provided. The blower uses a high-capacity sirocco fan developed to reduce the noise level. The

lighting unit is an energy-saving LED lighting device that uses one 10W LED lamp and produces almost the 

same illumination as a standard 40W incandescent lamp. Night light feature consumes around 0.1 to 0.4 W.

(FV-0511VQCL1 only)

This Panasonic ventilating fan model is equipped with a motion sensor and a humidity sensor that turn 

on automatically when motion is detected, when humidity increases rapidly, or when humidity rises above 

a 30% ~ 80% relative humidity set-point. It is user-adjustable to operate 0.5 ~ 60 minutes after the sensors 

are no longer detected.

4

Summary of Contents for FV-0511VQL1













Reviews: