background image

GENERAL SAFETY INFORMATION CONTINUED

This product must be properly grounded.

Make sure that the electric service supply voltage is AC 120 V, 60 HZ.

Protect the supply wiring from sharp edges, oil, grease, hot surfaces, 
chemicals or other objects.

Do not kink the supply wiring.

Provide make up air for proper ventilation.

Not for use in cooking area. (Fig B)

The special-purpose or dedicated parts, such as mounting fixtures, 
must be used if such parts are provided.

The product

must

use

LED

lamp (model

:

11BR30G4DIM

/

927

/

GU24)

from

the

company

Green

Creative.

Do not install the unit where ducts are configured as shown 
in Fig A.

For general ventilating use only. Do not use to exhaust hazardous or 
explosive materials and vapors.

Always disconnect the power source before working on or near the 
light fixture or junction box.

Follow all local electrical and safety codes, as well as the National 
Electrical Code (NEC) and the Occupation Safety and Health Act (OSHA).

Do not install this recessed luminaire where interior room temperature 
may exceed 104

 °

F (40

 °

C).

WARNING

CAUTION

3

DESCRIPTION

The lighting product is a lighting device that uses one 11 W BR30 shape LED lamp (model

:

11BR30G4DIM

/

927

/

GU24, from the company Green Creative) and produces almost the same 

illumination as a standard 65 W incandescent lamp.

The trim ring is a spring-loaded, quick remove type. A damper for preventing air counterflow is 
provided.

FCC Note: This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by turning this 
product on and off, the user is encouraged to try to correct the interference by one of the following 
measures:
  Reorient or relocate the receiving antenna.
  Increase the separation between the equipment and receiver.
  Connect equipment into outlet on a circuit different from that to which the receiver is connected.
  Consult the dealer or an experienced radio/TV technician for help.

This Panasonic recessed

luminaire model is listed by UL under UL file No. E484859.

Extreme 
bending

Prohibited

Prohibited

Prohibited

Prohibited

Floor

45

°

Adaptor

    (Cooking area)
Do not install above 
  or inside this area

  Cooking 
equipment

     Bend 
repeatedly

   Duct 
narrow

Bend near 
adaptor

Fig B

Fig A

45

°

Please wear gloves when installing or cleaning this recessed luminaire.

Summary of Contents for FV-NLF46RES









Reviews: