The microphone volume is small.
Increase the volume of the microphone according to the following steps.:
1.
Touch
(All apps) - [Windows System] - [Control Panel].
2.
Touch [Hardware and Sound] - [Sound] - [Recording] - [Microphone Array] - [Prop-
erties], and then increase the volume of [Microphone Array] and/or [Microphone
Boost] in [Levels].
When signing in (e.g., resuming the com-
puter), audio is distorted.
Perform the following steps to change the audio settings to prevent audio output.
1.
Touch and hold
(Speaker) on the task tray, and touch [Sounds].
2.
Remove the check mark from [Play Windows Startup sound].
The feedback noise may occur.
To stop microphone's monitoring output.
1.
Touch
(All apps) - [Windows System] - [Control Panel].
2.
Touch [Hardware and Sound] - [Sound] - [Recording] - [Microphone Array] - [Prop-
erties], and then remove a check mark for [Listen to this device] in [Listen].
Input Characters
Cannot enter special characters (ß, à, ç,
etc.) and symbols.
Use the character map.
1.
Touch
(All apps) - [Windows Accessories] - [Character Map].
2.
Input “Character”.
Network
<Only for model with LAN>
Cannot connect to a network.
Set the device
to [Enabled] in the [Advanced] menu of the Setup Utility.
<Only when using the Cradle with LAN>
Cannot connect to a network.
Set
to [Enabled] in the [Advanced] menu of the Setup Utility.
Cannot check the computer's MAC
address.
Follow the steps below.
1.
Touch
(Settings).
2.
Touch [Network & Internet] - [Status] - [View your network properties].
Properties of each device appears.
Write down the 12-digit address (alphanumeric) that appears for “Physical address
(MAC):” rows of each devices.
The names of each of the devices are as follows.
Device
Connection name
Wireless WAN
Cellular
<Only for model with LAN>
Wired LAN
Ethernet
Wireless LAN
Wi-Fi
Bluetooth
Bluetooth Network Connection
* The content displayed will vary depending on the device and model.
3.
Touch
to close the window.
-
115
-