*16:
Do not expose the skin to this product when using the product in a hot or cold environment. (
OPERATING INSTRUCTIONS - Read Me First)
When using in hot or cold environment, some peripherals may fail to work properly. Check the operation environment of the peripherals.
Using this product continuously in a hot environment will shorten the product life. Avoid use in these types of environments. When using in low tem-
perature environment, startup may become slow or battery operation time may become short.
The computer consumes power when the SSD is warming up during startup. Therefore, if you are using battery power and the remaining power is
low, the computer may not start up.
<Only for North America>
UL60950 – 1 Evaluated for use at ambient temperatures up to 35 °C {95 °F} when used with optional AC Power Adaptor and 40 °C {104 °F} when
used without AC power adaptor.
*17: Operations of this computer are not guaranteed except for the pre-installed OS and the OS which is installed by using the flash memory recovery
and the recovery disc.
*18: To continue using this software after the end of the trial, purchase a license by following the on-screen instructions.
*19: Must be installed before use.
*20: For localized OS model. For information on Wireless Manager, refer to the “Supplementary Instructions” by the following procedure.
1.
Touch and hold
(Start) at the bottom left corner.
2.
Touch [Run], input “c:\util\wlprjct\Supplementary Instructions.pdf” then touch [OK].
*21: Only for model with barcode reader.
*22: Only for model with GPS or wireless WAN.
*23: Panasonic PC Settings Utility includes the following functions: Touch Screen Mode / Touch Operation Support / etc.
*24: Only for model with Thermography Camera.
*25: Only for model with 3D Camera.
*26: Perform on the recovery disc.
*27: These are speeds specified in IEEE802.11a+b+g+n+ac standards. Actual speeds may differ.
*28: Available when set to “WPA-PSK”, “WPA2-PSK” or “none”.
Only available when HT40 enabled by the computer and access point which associated supports HT40.
*29: The specifications may differ depending on the model.
A microSIM card (12 mm {0.47”} × 15 {0.59”} mm) must be inserted in the microSIM card slot.
*30: Exclusively configurable by selecting one from Serial Port or LAN Port or Barcode reader or USB 2.0 Port.
*31: Exclusively configurable by selecting one from Wireless WAN (with GPS) and GPS.
The model number is described on the computer
Check according to the procedure below.
1.
Turn over the computer.
Make sure no foreign objects are under the computer.
2.
Remove the battery pack.
1.
Slide the latch (A).
2.
Remove the battery pack (B).
-
138
-