29
5.1.10. Time Config
Select "Basic Config" and then "Time Config" to open the screen shown in Figure 5-
10. On this screen, you can configure the SNTP synchronization settings.
Figure 5-10 Time Configuration of This Switch
Screen Description
Note:
In case the SNTP server is located outside of the firewall, connection with the
SNTP server may not be possible depending on settings by the network
administrator. For details, ask your network administrator.
If you wish to disable the time synchronization function, set the SNTP server
to "0.0.0.0."
Time Zone
Displays the time zone.
Daylight Saving
Displays the application status of Daylight Saving (Summer time).
In case the set time zone is a zone where Daylight Saving is not applied, "N/A"
is displayed, and this configuration is not available.
When this switch is used domestically, this configuration is not required.
Time
Displays the time configured manually.
Date (Year/Month/
Day)
Displays the date configured manually.
Update from PC
Clock
Obtains the date and time from the PC's clock.
SNTP Server
Displays the IPv4 address of the SNTP server that executes time synchroniza
-
tion.
SNTP Update Inter
-
val
Displays the interval time for SNTP synchronization.
