Page 6 of 17
Model
Name
Model
No.
GA-M+
PN260496-TH
Product Specification
401-260496-TH-SP05
Date issued
Date revised
Jun. 29, 2021
Apr. 1,2022
Panasonic Electric Works Networks Co., Ltd.
5. Hardware Specifications
You can display the following items using the LED display change button.
Display for the connection with a connected terminal (Status mode),Display for
the 1000 Mbps transmission rate (GIGA mode) , Display for the full-duplex or half-
duplex transmission system (DUPLEX mode), Display for ports with a loop history
(Loop history mode) , All port LED lamps can be turned OFF (ECO mode).
The mode at the start is called “Base mode”.
There are two types of Base modes : Status mode (factory default setting) and ECO
mode.
You can change the Base mode by holding down the LED display change button
(for at least 3 sec).
When the Base mode is changed normally, all STATUS/ECO , GIGA and FULL LED
lamps light up at the same time. When you release the button, the Base mode is
changed to the selected mode.
If the mode is changed to the GIGA mode, DUPLEX mode, or Loop History mode and
the LED display switch button is not used for one minute or longer, the mode
automatically returns to a Base mode (Status mode or ECO mode).
The Base mode is maintained even after the power is turned OFF.
LED display change button
5－4. LED display
Press “LED DISPLAY CHANGE BUTTON” manually.
Automatically returns to Base mode after 1 minute.
Automatic
When Base mode is ECO mode
LED lamps for each mode and LED lamps for ports 1 to 6 correspond as the following.
（Table 1）
Switch Base mode（keep pressing “LED DISPLAY
CHANGE BUTTON” over 3 seconds）
Loop History
mode
ECO mode
（Base mode）
Boot
Status
mode
GIGA
mode
DUPLEX
mode
Status mode
(Base mode)
GIGA mode
Boot
DUPLEX
mode
Loop History
mode
Switch two types of Base mode s and their LEDs in the following way:
When Base mode is Status mode （factory default setting）
Press “LED DISPLAY CHANGE BUTTON” manually.
Automatically returns to Base mode after 1 minute.
Automatic
