15
Connections
p
w
Connections to the HD Visual Communication Unit and AC adapter
HD Visual Communication Unit
KX-VC300, KX-VC600
HDMI cable (sold separately)
This unit
Power cable
AC adapter
p
p
For details on how to operate the unit and select its settings, refer to the operating instructions of the HD Visual
Communication Unit to be connected.
p
w
Connecting the IR system cable (sold separately)
p
p
By connecting an IR system cable (sold separately), the camera can be operated in response to the signals received from the
remote controller which is pointed at the camera’s remote controller signal receivers. (IR repeater function)
For details on the IR repeater function, refer to page 12.
HD Visual Communication Unit
Rear panel connector area
Transmitter
Point the transmitter at the remote
control signal receiver, and attach it
to the mounting position.
IR system cable
Use a strip of double‑sided
tape to adhere the cable to the
equipment or shelf.
Mounting position
Remote control
signal receiver
After mounting the transmitter,
verify that it performs the intended
operations at the time of its
installation. (See page 16)
p
p
Thoroughly remove the dirt and dust in the area where the tape is to be adhered.
p
p
Bear in mind that the strip of double‑sided tape supplied is extremely adhesive so if the tape is peeled off with too much
force after it has been adhered to a shelf or other surface, the shelf or surface may be damaged.
Notes
