10
6.4.
Assembly Flow Chart
6.5.
Assembly procedure
Important:
1. When tightening the screw, use a torque driver
(RFKZ0456) by ordering the screwing order with specified
torque described in each step.
2. Due to prevent loosen screw, the screw has been used to
the metal part must be used new screw.
(Non-reusable screw)
6.5.1.
Installation of the SHADING FRAME
1. Install the SHADING FRAME.
2. Tighten 2 screws (B) in numerical order by using the
torque driver with specified torque.
6.5.2.
Installation of the the FILTER RING
UNIT and the SLIDE HOOD UNIT
1. Slide the SLIDE HOOD UNIT arrow direction and install
to the FILTER RING UNIT.
2. Turn the FILTER RING UNIT arrow direction and install to
the LENS MAIN UNIT.
Fully turn to the end, drive a screw (A) with specified
torque.
