- 44 -
It can be zoomed up to 20
k
.
≥
It can zoom up to approx. 40
k
when the [i.Zoom] is set to [ON]. (
≥
Zoom magnification can be checked in the screen display of Z00 to Z99. The value gets larger
when zoomed in, and the value gets smaller when zoomed out.
If you set [i.Zoom] to [ON], the magnification level will be displayed as follows:
j
iZ00 to iZ99: optical zoom range
j
Z99: i.Zoom
∫
Zooming with the multi-manual ring
You can also perform zooming by rotating the multi-manual ring.
≥
You can also adjust focus and iris with the multi-manual ring. (
)
∫
About the zoom speed
≥
The zoom speed will vary depending on how far the zoom lever is pressed or how fast the multi-
manual ring is rotated.
≥
The zoom operation using the sub zoom lever will be performed at a constant speed. Zoom
speed of the sub zoom lever will vary depending on the setting of [SUB ZOOM]. (
)
≥
If you take your finger off the zoom lever during zoom operation, the operation sound may be
recorded. When returning the zoom lever to the original position, move it quietly.
≥
The sound of the zoom mechanism becomes louder than usual during fast zoom operation. This
may cause the sound to be recorded during recording.
≥
It can be focused approximately 1.5 m (4.9 feet) or further when the zoom magnification is at its
maximum.
≥
It can be focused approximately 3.0 cm (1.2
q
) or further when the zoom magnification is set to
1
k
.
Utilizing the USER button
Digital zoom can be used by assigning <D.ZOOM> to a USER button. (
)
≥
for details about setting the USER button.
Using the zoom
Zoom lever
1
/Sub zoom lever
2
T side:
Close-up recording (zoom in)
W side:
Wide-angle recording (zoom out)
Multi-manual ring
3
A side:
Wide-angle recording (zoom out)
B side:
Close-up recording (zoom in)
T
T
W
W
W
W
T
T
W
W
A
B
A
B
