- 77 -
≥
The setting will be turned off in the following cases:
j
If you turn the unit off
j
When the mode switch position is changed
j
If you switch to Intelligent Auto Mode
≥
This function will fix the shutter speed to 1/60. The shutter speed cannot be adjusted.
≥
Register <PRE-REC> to a USER button. (
This allows the recording of an image and audio to start before you press the recording start/stop
button. AVCHD scenes will be recorded from approximately 3 seconds before the operation, while
MOV/MP4 will be recorded from approximately 4 seconds before the operation.
≥
[P-] is displayed on the screen. After you start recording, the display changes to [P-REC].
≥
Aim the unit at the subject beforehand.
≥
There is no beep sound.
≥
This function is not available in the following cases:
j
During Super Slow Recording (
)
j
During the Interval Recording (
≥
In the following cases, a 3 second image that precedes the recording of an AVCHD scene or a
4 second scene that precedes the recording of an MOV/MP4 scene may not be recorded:
j
Immediately after the maximum PRE-REC standby time has elapsed*
j
If the length of time from when [PRE-REC] is set to [ON] to when you start recording is too
short
j
When the unit is turned off and on or the mode switch position is changed after PRE-REC is set
so the length of time from when you switch to the recording screen until when you start
recording is short.
j
When the card slot selected for motion picture recording is switched automatically because you
started recording with normal settings or when [2 SLOTS FUNC.] is set to [RELAY REC]
(
)
* The maximum PRE-REC standby time is 3 hours. Once PRE-REC is activated, it is automatically
deactivated and then re-activated every 3 hours.
≥
Images displayed on the thumbnail in Playback Mode will differ from the motion pictures
displayed at the start of playback.
<PRE-REC>
