- 160 -
Using [Baby Monitor]
1
Press Wi-Fi button on this unit and touch [Baby Monitor].
≥
The SSID of the wireless access point to which this unit is connected is displayed.
2
Connect the smartphone to a wireless access point.
≥
To connect it, select the SSID of the wireless access point displayed on the screen of this unit.
3
Start up the smartphone application “Image App”.
≥
When this unit is connected to the Internet via the wireless access point, the notification function,
which sends notifications from this unit to the smartphone, becomes available.
≥
When the connection is complete, the screen of this unit turns off. To turn on the screen again,
touch the screen.
To exit [Baby Monitor]:
Touch [EXIT] displayed on the screen of this unit or press the Wi-Fi button.
≥
The message is displayed. Touch [YES] to close the indication.
∫
Checking on the baby in your house
You can check the image of the baby being monitored on your smartphone.
≥
Images of baby-monitoring cannot be recorded.
≥
It cannot be confirmed with multiple smartphones simultaneously.
∫
Voice message function
The smartphone and this unit can be used like radio transceivers, allowing the users to have a
conversation by taking turns.
≥
A voice message of up to 1 minute can be sent.
≥
Open the LCD monitor of this unit when using the Voice message function.
∫
Sending notifications to your smartphone
In the following cases, this unit sends a notification to the smartphone:
≥
When baby monitoring starts
≥
When a sound is detected
∫
Sound detection
When this unit detects a sound, it can automatically send a notification to the connected
smartphone.
≥
This function can be used only if this unit is connected to the Internet via the wireless access
point when [Baby Monitor] is used.
≥
Depending on the sound detection sensitivity setting and recording conditions, sounds may not
be detected. Test the sound detection function in advance to check if sounds can be detected and
notified.
What you can do with [Baby Monitor]
