- 164 -
7
Touch the desired Network Authentication method.
≥
When [WEP] is selected, proceed according to step 9.
8
Touch the desired Encryption method.
≥
If you select [NONE], a message is displayed after completing the connection. Touch [ENTER],
and exit [Wireless Settings].
9
(When selecting [WEP]/[TKIP]/[AES])
Touch [INPUT], then enter the Password.
≥
For details on how to enter characters, refer to page
≥
When the entry is complete, touch [Enter].
≥
A message is displayed when the connection is complete. Touch [ENTER], and exit [Wireless
Settings].
≥
Check the wireless access points instruction manual and settings when a saving wireless access
point.
≥
The Encryption methods are [AES], [TKIP] and [WEP] in descending order of strength. We
recommend you connect with the strongest possible Encryption method.
≥
When the signal of the wireless access point is weak, a connection may not be established. Refer
to “Messages” (
) and “Troubleshooting” (
) for details.
≥
Transmission speed may decrease, or may not be usable depending on the environment it is
used in.
Setting up a connection manually
Network authentication type
Encryption types that can be set
[Open]
[NONE]/[WEP]
[WEP]
There is no setup of an encryption types.
[WPA-PSK]/[WPA2-PSK]
[TKIP]/[AES]
Confirming that the Wi-Fi connection is complete
j
The status indicator of this unit is lit green
j
is displayed on the screen
