Audio input – Switching the audio input
184
Using the built-in microphone
1
Set the CH1 SELECT switch to the <INT(L)> position.
The audio signals from <L> of the built-in microphone are recorded to audio channel 1.
2
Set the CH2 SELECT switch to the <INT(R)> position.
The audio signals from <R> of the built-in microphone are recorded to audio channel 2.
Using audio equipment/external microphone (XLR, 3-pin)
1
Connect an audio device or an external microphone to the <AUDIO INPUT1>/<AUDIO
INPUT2> terminal.
2
Switch the connected audio input with the <INPUT1>/<INPUT2> switch.
(A) <INPUT1> switch
(B) <INPUT2> switch
*1 Factory setting: [
j
50dB]
*2 Factory setting: [0dB]
•
To decrease the wind noise of the microphone, select the [AUDIO] menu
¨
[REC CH SETTINGS]
¨
[CH1 MIC LOWCUT]/
[CH2 MIC LOWCUT]
¨
[ON].
Connected device
<INPUT1>/<INPUT2> switch
setting
Menu settings (you can set each channel individually)
[INPUT1 MIC LEVEL]/[INPUT2
MIC LEVEL]
*1
[INPUT1 LINE LEVEL]/[INPUT2
LINE LEVEL]
*2
Audio device
<LINE>
Disabled
[4dB], [0dB]
External microphone
<MIC>
[
j
40dB], [
j
50dB], [
j
60dB]
Disabled
External microphone (with power
supply)
<
i
48V>
[
j
40dB], [
j
50dB], [
j
60dB]
Disabled
•
When using a Unidirectional microphone AG-MC200G (optional), set [INPUT1 MIC LEVEL]/[INPUT2 MIC LEVEL] to
[
j
50dB].
•
After detaching the external microphone (XLR, 3-pin), switch the CH1 SELECT/CH2 SELECT switch to <INT(L)> or
<INT(R)> to set the input signal to the built-in microphone. No audio will be recorded if you continue to record as is.
•
When connecting equipment that does not s48 V power supply, set the <INPUT1>/<INPUT2> switch to
<LINE> or <MIC>. If set to <
i
48V>, this unit or the connected equipment may malfunction.
•
If an abnormality occurs with the +48 V power supply, the power of this unit will turn off.
•
Using a phantom microphone shortens the battery time.
•
When noise from unconnected terminals is bothersome, set the <INPUT1>/<INPUT2> switch to <LINE>.
LINE
INPUT2
MIC
＋48V
LINE
INPUT1
MIC
＋48V
(A)
(B)
