45
<HOME>
Registering TCG values
1.
2.
3.
Selecting the values
Press the TC/CTL button to select TC.
Press the
button. The selected item (cue time
or TC) is now highlighted.
Turn the ADJUST dial to select TC.
Again press the
button. A single digit is
highlighted, and the mode for inputting numerical
values is established.
<Notes>
• The UBG value and cue time can be registered
in the same way. The CTL value cannot be
registered.
• TC or UB can be registered only when the
internal time code generator has been selected.
T
T
Inputting numbers and letters
Press the
to
number keys to input
numerical values.
Use the
+
buttons to input A, B and C, and
the
+
buttons to input D, E and F.
To move the input digit, turn the ADJUST dial.
To input a minus sign, press the
and
]
buttons when the left-most digit is highlighted.
To input a plus sign, press the
and
]
buttons when the left-most digit is highlighted or
press the
button.
(The display goes blank.)
To clear all the digits to zero, press the
and
buttons.
<Notes>
• When the
button is tapped while the
button is held down, the display changes in the
following sequence: A
>
B
>
C
>
A
>
B and
so on. The same applies when D, E and F are
input using
and
.
• If, when “REV” has been selected as the setup
menu item No.144 (TC INPUT) setting, the
button is released while a letter is being input,
the displayed character will be entered.
• Letters can be input only while a UBG value is
being registered.
• The input of a minus number is possible only
while the cue time is being registered after
“
d
12h” is selected as the setup menu No.002
(TAPE TIMER) setting and CTL is selected by
the
TC/CTL button.
• If “REV” has been selected as the setup menu
item No.144 (TC INPUT) setting, the input
starts from the highest order digit (the display
appears from the far right). However, turning
the ADJUST dial once will restore the NORMAL
input mode.
F3
F
8
F
F
7
0
F
0
TRIM
i
F
TRIM
j
F
8
F
7
F
9
0
Entering the input values
Press the
button. The value input is
registered, and the normal display is restored.
<Notes>
• To cancel the registration, press the
button.
• If the input value is outside the registration
enable range, the
alarm blinks, and
the value cannot be registered until it has been
corrected.
INVALID
C
ENT
Function menus
HOME
F3
Summary of Contents for HD1700pe
Page 133: ...133 ...
