12
VQT1N45
Quick Guide
∫
Charging the battery
1
Connect the AC cable to the AC adaptor
and the AC outlet.
2
Insert the battery into the battery charger
by aligning the arrows.
∫
Inserting the battery
Open the LCD monitor and install
the battery by inserting it in the
direction shown in the figure.
A
Insert the battery until it clicks and locks.
∫
How to turn on the power
Turn on the power by sliding the
mode switch to
or
while
pressing the lock release button
A
.
≥
Operate the mode switch while at the same
time pressing in the lock release button if
changing from OFF to another mode.
≥
Status indicator
B
≥
To turn off the power, set the mode switch to
OFF.
∫
Inserting/removing an SD card
1
Set the mode switch to OFF.
2
Open the SD card cover while sliding the
SD CARD OPEN lever
B
.
3
Insert/remove the SD card.
≥
When inserting an SD card, face the terminal
side
C
in the direction shown in the illustration
and press it straight in as far as it will go.
≥
When removing the SD card, press the center
of the SD card and then pull it straight out.
4
Securely close the SD card cover.
≥
Securely close it until it clicks.
∫
Language selection
1) Press the MENU button, then select
[LANGUAGE] and press the cursor button.
2) Select [English] and press the cursor button.
Charging lamp
[CHARGE]
A
Lights up:
Charging
Goes off:
Charging
completed
Card access lamp [ACCESS]
≥
When this unit is processing data, the
access lamp
A
lights up.
OPEN
SD CARD
HDCSD9P-VQT1N45_ENG.book 12 ページ ２００７年１２月２６日 水曜日 午後５時５７分
