POWER ON/OFF
7
z
ENGLISH
POWER ON/OFF
Connecting the Plug to the Wall Outlet
The projection TV must first be plugged into an AC outlet.
The projection TV will then be in standby mode.
Turning the Power ON and OFF
Always be sure to follow the procedure below to turn the
Projection Television power ON and OFF.
The lamp cooling fan will continue to operate for
approximately one minute after the power is turned off by
the remote control.
After the cooling fan has stopped, the power indicator will
not illuminate (Stand-by mode). If you wish to turn the
power ON while the cooling fan is operating, press the
power button. The power indicator on the Projection
Television will then flash in green, and the projection
Projection Television will turn ON as soon as the cooling
fan stops. Always use the remote control or power button
on the Projection Television to turn the power OFF.
Caution:
Do not turn off by external power strip or by
pulling plug. Do not open any circuit breakers
while the cooling fan is still operating.
Procedure for turning ON
•
Press the Power button to turn the projection TV on, from
Stand-by mode.
Note:
The Power Indicator will blink green for
approximately 10 seconds, and then become
green.
Procedure for turning OFF
•
Press the Power button to turn the projection TV to
Stand-by mode.
Notes:
•
The Power Indicator will become orange for
approximately 10 seconds.
•
The Power Indicator will blink orange for approximately 60
seconds.
•
The Power Indicator light will go out.
Note:
The Projection Television will consume a small amount
of power as long as the power cord is connected to a
power outlet.
Power Indicator Chart
Initial Set Up Menu
For your convenience, the Initial Set Up menu will be
displayed on screen when the set is turned on for the first
time. If needed, follow the menus and procedures for
setting up the features.
IDIOMA/LANGUE
To change menu language to ENGLISH, SPANISH or
FRENCH.
Procedure
•
Press
VOL
X
to select English, Spanish or French.
MODE
To select TV (antenna) or CABLE mode depending on the
signal source.
Procedure
•
Press
VOL
X
to select TV or CABLE.
AUTO PROGRAM
To automatically program all channels received through the
RF input.
Procedure
•
Press
VOL
X
to start Auto Programming.
LED
ACTION
Not illuminated
Stand–by
Green
Power – ON
Green blink
Power – ON
(approximately 10 seconds after)
Orange
Power – OFF (Blinking mode)
(approximately 10 seconds after)
Orange blink
Power – OFF (Cooling mode)
(approximately 40 seconds after)
INITIAL SET UP
IDIOMA/LANGUE
MODE
AUTO PROGRAM
ENGLISH
CABLE
PRESS MENU TO EXIT
FIRST PLEASE
CONNECT THE ANTENNA
INITIAL SET UP
IDIOMA/LANGUE
MODE
AUTO PROGRAM
ENGLISH
CABLE
PRESS MENU TO EXIT
FIRST PLEASE
CONNECT THE ANTENNA
INITIAL SET UP
IDIOMA/LANGUE
MODE
AUTO PROGRAM
ENGLISH
CABLE
PRESS MENU TO EXIT
FIRST PLEASE
CONNECT THE ANTENNA
Summary of Contents for HDTV DLP PT-60DL54
Page 36: ...34 z NOTES ENGLISH ...
Page 37: ...NOTES 35 z ENGLISH ...
