39
• Before connection, make sure the voltage on the
indentification label is consistent with the actual network
voltage.
• The length of the power cord should be at least 1.5 meters;
thus, the appliance can be connected before it is pushed to
the wall.
• The length of the power cord should be adjusted in such
a way that in case of pulling load on the cable, the ground
wire is strained later than the voltage wires.
Procedure
• Use a screwdriver to open the cover of the connection
terminal on the back of the appliance. Release the two
clips as indicated on the cover of the connection terminal.
• The mains cord must be inserted into the strain release
device which protects the cable from being pulled out.
If the strain release device is not installed yet, install it
in such way that it gets stuck in the connection terminal
housing at one end.
• Then, connect the appliance according to the instructions
indicated on the figures.
• Firmly fasten the strain release device and close the cover.
NEUTRAL
EARTH
LIVE
Links stored
here
Connecting the wires
1. Connect the live (brown) wire to connection position 3.
2. Connect the neutral (blue) wire to connection position 4.
3. Connect the earth (green and yellow) wire to the
connection marked . Make sure the earth wire is longer
than the live and neutral wires.
4. Tighten all the connection screws.
5. Un-screw the cable clamp and place the cable under the
clamp and then screw the clamp closed.
6. Close the connection box and click the lid into place.
Inserting the links
Before connecting the mains cable you may have to fit the 3
links. The links are stored as shown opposite.
• Insert 1 link between positions 1 and 2.
• Insert 1 link between positions 2 and 3.
• Insert 1 link between positions 4 and 5.