5
Installation and Connection
Oven connection should be carried out in compliance with the instructions in the section
“Connection to the power mains” (see page 38), and the relevant effective regulations and
standards.
The appliance must be properly earthed for personal safety.
Servicing and Repairs
Servicing and repairs should only be carried out by a qualified electrician. If the appliance is
defective, disconnect from mains or switch off the appliance at the circuit breaker in the fuse box.
Contact the nearest authorised dealer.
Sprays, areosols and inflammable subtances
Spray canisters, areosols and other inflammable substances can ignite when heated. Do not store
or use such item near the oven.
This manual constitutes an integral part of the appliance. It should be kept intact and at hand for the
appliance’s entire life cycle. It is important to carefully read this manual and all of the instructions
contained herein before using the appliance.
WARNING
Only a qualified electrician may connect the appliance.
WARNING
You will lose your warranty entitlement in the event of any damage caused by incorrect
installation.
Important safety instructions
Examine your oven
Please make sure the appliance was supplied to you undamaged. Remove all packaging and
examine the oven for any damage such as dents, broken door latches or cracks in the door. If you
find any damage, notify your dealer immediately. Do not install a damaged oven.
Identification label
The identification label indicating the basic information of the appliance is attached to the inside of
the oven and is visible when you open the door. (see page 8). Do not remove the label.
WARNING
Remove all internal and external packaging. Please ensure all internal packaging is
removed before switching the oven on.