1. Check that the Gatewayʼs Application
LED is flashing in green.
2. Hold the Register Button inside the
battery cover of the Temperature /
Humidity Sensor for at least 2 seconds
to enter registration mode.
3. Once the Temperature / Humidity
Sensorʼs Register Lamp changes from
a flashing red to a permanent red,
registration is complete (the LED will
turn off after 5 seconds).
4. Tap the “Check” button to move on.
Setup the Temperature / Humidity Sensor
Installer Tasks
Tapping the “Next”
button on the final
page of
displays the screen
to the left.
Insert the lithium
battery which
came with the
Temperature /
Humidity Sensor.
Tap the “Next”
button.
Tap the
“Activate regis-
tration mode”
button to start
the Gatewayʼs
device registra-
tion mode.
Tap the “Temperature /
Humidity Sensor” button
to start registration.
Insert the lithium battery
into the Temperature /
Humidity Sensor.
2
1
Put the Gateway into
registration mode.
3
Press the Register Button on the
Temperature / Humidity Sensor
and register it to the Gateway.
4
Registration will take
around 30 seconds.
Note
STEP3
STEP1
24
