142
Connection with external device : Connection with external devices using the USB 2.0 port
7
When the writing is completed, the message “COPY
COMPLETED!” is displayed.
Note
If a clip is written back to a P2 card different from the
original card that contained that clip, then the clip may be
incomplete. If this is the case, reconnect the clip. For more
information, see [Reconnection of Incomplete Clips] (page
124).
z
A hard disc drive (including the P2 STORE (AJ-PCS060G))
must be used under the following conditions:
It must meet the operating requirements (e.g.
temperature).
It must not be placed in an instable place or a place
exposed to vibrations.
z
Some hard disc drives do not operate properly.
z
Some hard disk drives with the SATA (Serial ATA)
interface or the PATA (Parallel ATA) interface connected
by a USB conversion cable may not be recognized.
z
When copying data, a hard disc drive must have
sufficient free space.
z
Do not remove the cable or the target P2 card or turn off
the camera-recorder or hard disc drive during formatting
or copying. Doing so requires the camera-recorder and
the hard disc drive to be reactivated.
z
Since hard disc drives are high precision devices, there
is a high possibility that they may become incapable of
writing data depending on the conditions of use.
z
Take note that we will not be liable for loss of data
caused by failed hard disc drives or any other
problem as well as direct or indirect damages
resulting from the loss of data.
z
We do not guarantee that hard disc drives will operate
properly with the camera-recorder or that the data on
them will be properly retained if data copied to them from
the camera-recorder has been replaced with other data
using a PC.
z
By using the drive mount converter distributed on the
following URL, the hard disk drive can be mounted in the
designated folder when connected.
https://eww.pavc.panasonic.co.jp/pro-av/
Direction for using a hard disc drive
AJ-HPX3000G(VQT1K82-5)E.book 142 ページ ２００９年１１月１２日 木曜日 午後８時１９分
