PAGE 28
SMED SEMI VERTICAL - HUSSMANN
CAUTION:
Do NOT use HOT(+35
0
C or
lower) water on COLD glass surfaces.
This can cause the glass to shatter and
could result in personal injury. Allow
glass fronts, ends and service doors
to warm before applying hot water. Do
NOT use hot water inside the case.
CAUTION:
Power to the case needs
to be turned off when cleaning, ensure
the fans are off during this process.
REMINDER: when cleaning completed,
check all items are ready to go, then
safely reconnect power.
DO USE:
Long life and satisfactory performance of any
equipment is dependent upon the care it receives.
To ensure long life, proper sanitation and minimum
maintenance costs, these merchandisers should
be thoroughly cleaned, all debris removed and the
interiors washed down, weekly.
To facilitate cleaning, the fan plenum is hinged and also
fastened with screws at each end. After cleaning be sure
the plenum is properly returned into position and that
screws are reinstalled or performance loss will result
due to improper refrigeration.
• Abrasive cleansers and scouring pads, as these will
mar the finish.
• Coarse paper towels on coated glass.
• Ammonia or sovent-based cleaners on acrylic parts.
• Solvent, oil or acetic based cleaners on any interior
surfaces.
The interior surfaces may be cleaned with mild domestic
detergents.
The exterior surfaces should be cleaned with a mild
detergent and warm water to protect and maintain
their attractive finish. Never use abrasive or solvent
based cleaners and scouring pads.
Remove the product and all loose debris to avoid
clogging the waste outlet.
• When deep cleaning cabinets that may require the
removal of the refigerated product, ensure this is
stored in a suitable refrigerated area to maintain
the cold chain.
• Then turn off refrigeration, then safely disconnect
electrical power.
• Thoroughly clean all surfaces with appropriate
cleaners noted previously. Do not use steam or
high pressure water to wash the interior. These
may damage the merchandisers’ sealing causing
leaks and poor performance.
• Remove
screws and lift hinged fan plenum
for
cleaning. Be sure to reposition the fan plenum after
cleaning merchandiser.
• Avoid water contact on all electrical components
includng fan motors and lights.
4.2
CARE AND CLEANING
FAN PLENUM
INTERIOR SURFACES
DO NOT USE:
EXTERIOR SURFACES
CLEANING & MAINTENANCE