20
Configure the settings relating to the NTP server [NTP]
Click the [NTP] tab on the "Basic setup" page. (
☞
page 18)
The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured on this
page.
[Time adjustment]
Select the time adjustment method from the following.
Manual setup:
Time set on the [Basic] tab on the
"Basic setup" page will be used as the standard time
of the unit.
Synchronization with NTP server:
Time automatically
adjusted by synchronizing with NTP server will be
used as the standard time of the unit.
Default setting:
Manual setup
[NTP server address]
Enter the IP address or the host name of the NTP serv-
er.
Number of characters that can be entered:
1 - 128
characters
Default setting:
(blank)
Important:
When entering the host name for "NTP server
address", it is necessary to configure the DNS set-
tings on the [Network] tab of the "Network setup"
page. (
☞
page 42)
[NTP port]
Enter a port number to be used for the NTP server.
Available port number:
1 - 65535
Default setting:
123
[Synchronization interval]
Select an interval (1 - 24 hours: in 1 hour intervals) of
synchronization with the NTP server.
Default setting:
1 hour
[Time zone]
Select a time zone according to the location where the
unit is in use.
Default setting:
(GMT) Greenwich Mean Time: Dublin,
Edinburgh, Lisbon, London
