39
Configure the settings of the servers [Server setup]
The settings relating to the mail server and the FTP server can be configured on this page.
The "Server setup" page has 2 tabs of the [Mail] tab and the [FTP] tab.
Configure the settings relating to the mail server [Mail]
Click the [Mail] tab on the "Server setup" page.
The settings relating to the mail server used to send the alarm mail can be configured on this page.
[SMTP server address]*
Enter the IP address or the host name of the SMTP
server used to send e-mails.
Number of characters that can be entered:
1 - 128
characters
Default setting:
Blank
[POP server address]*
When "POP before SMTP" is selected for
"Authentication", enter the IP address or the host name
of the POP server.
Number of characters that can be entered:
1 - 128
characters
Default setting:
Blank
Important:
When entering the host name for "NTP server
address", it is necessary to configure the DNS set-
tings on the [Network] tab of the "Network setup"
page. (
☞
page 42)
[Authentication]
Select the authentication method to send e-mails from
the following.
None:
It is not necessary to clear any authentication to
send e-mails.
POP before SMTP:
It is necessary to clear the POP
server authentication first to use the SMTP server to
send e-mails.
SMTP:
It is necessary to clear the SMTP server authen-
tication to send e-mails.
Default setting:
None
Note:
When you don’t know the authentication method to
send e-mails, refer to the network administrator.
[User name]
Enter the user name to access the server.
Number of characters that can be entered:
1 - 32
characters
Default setting:
Blank
[Password]
Enter the password to access the server.
Number of characters that can be entered:
0 - 32
characters
Default setting:
Blank
[Sender mail address]
Enter the mail address of a sender.
Entered mail address will be displayed in the "From"
(sender) line of the sent mails.
Number of characters that can be entered:
3 - 128
characters
