4
Glass Tray
1.
DO NOT
operate the oven without the Roller Ring and the Glass Tray in
place.
2.
DO NOT
operate the oven without the Glass Tray fully engaged on the drive
hub. Improper cooking or damage to the oven could result. Verify that the
Glass Tray is properly engaged and rotating by observing its rotation when
you press Start.
Note:
The Glass Tray can turn in either direction.
3. Use only the Glass Tray specifically designed for this oven.
DO NOT
substi-
tute any other glass tray.
4. If the Glass Tray is hot, allow to cool before cleaning or placing in water.
5.
DO NOT
cook directly on the Glass Tray. Always place food in a microwave
safe dish, or on a rack set in a microwave safe dish.
6. If food or utensils on the Glass Tray touch oven walls, causing the tray to stop
moving, the tray will automatically rotate in the opposite direction.
Roller Ring
1. The Roller Ring and oven floor should be cleaned frequently to prevent
excessive noise.
2. Always replace the Roller Ring and the Glass Tray in their proper positions.
3. The Roller Ring must always be used for cooking along with the Glass Tray.
IMPORTANT SAFETY INSTRUCTIONS
(continued)
Examine Your Oven
Unpack oven, remove all packing material and examine the oven for any dam-
age such as dents, broken door latches or cracks in the door. Notify dealer
immediately if oven is damaged.
DO NOT
install if oven is damaged.
Placement of Oven
1. The oven must be placed on a flat, stable surface. Place the front surface of
the door 7.6 cm (3-inches) or more from the counter top edge to avoid acci-
dental tipping of the microwave oven during normal use. For proper operation,
the oven must have sufficient air flow. Allow 7.6 cm (3-inches) of space on
both sides of the oven and 5 cm (2-inches) of space on the top of the oven.
(a)
DO NOT
block air vents. If they are blocked during operation, the oven
may overheat and be damaged.
(b)
DO NOT
place oven near a hot, damp surface such as a gas or electric
range, or dishwasher.
(c)
DO NOT
operate oven when room humidity is excessive.
2. This oven is manufactured for household use only. It is not approved or tested
for mobile vehicle, marine, or commercial use.
Installation
1.
DO NOT
block air vents. If they are blocked during operation, the oven may
overheat. If the oven overheats, a thermal safety device will turn the oven off.
The oven will remain inoperable until it has cooled.
2. If the oven is designed for installation into a wall cabinet, use the proper trim
kit available from a local Panasonic dealer. Follow all instructions packed with
the kit.
INSTALLATION AND
GROUNDING INSTRUCTIONS
F00037D63CP 2006.2.10 09:15 Page 6
