12
Setting the Clock
Example: To set 11:25 a.m. or p.m.
1.
• Press
Time/Clock
twice.
Colon flashes.
2.
• Set time of day by using Time Select
Dial.
Time appears in the display window;
colon continues flashing.
3.
• Press
Timer/Clock
once.
Colon stops flashing; time of day is
entered.
NOTES:
1. To reset the clock, repeat steps 1-3.
2. The clock will retain the time of day as long as the oven is
plugged in and electricity is supplied.
3. Clock is a 12 hour display.
4. Oven will not operate while colon is flashing.
Setting Light Hi-Warm/Hi-Cool/Low/Off
This feature allows you to control the
brightness of Cooktop Light.
Press "Light hi-Warm/hi-Cool/Low/Off"
button once for hi-Warm light, twice for
the hi-Cool light,three times for Low
light,and press again to turn the light off.
NOTE:
When "Turntable OFF" is selected, it will automatically return
to "On" again after the heating cycle is completed.
Do not
operate the oven "Turntable Off" when cooking foods
on Popcorn / Inverter Turbo Defrost / Sensor Reheat / Sensor
Cook.
Sometimes the glass tray can become too hot to touch
. Be
careful when touching the glass tray during and after cooking.
Setting Turntable On/Off
For best cooking results, leave the
turntable on. It can be turned off for
large dishes.
Press "Turntable On/Off" button to turn
the turntable on or off.
When you turn it off, will appear in
the display window.
NOTE: Automatic fan
If the microwave oven is used for a long time or if cooking
equipment under the microwave oven is used simultaneously,
the temperature may get too hot around the microwave oven
and the vent hood fan will automatically turn on at the Turbo
setting to cool the oven. When this occurs the display window
shows "
vENTILATINg
", and
the fan cannot be manually
turned off
. If subsequently another key is pressed and "
HOT
"
appears in the display window, the
microwave oven will not
operate
, and you must wait until the microwave is cool and
"
HOT
" disappears from the display to re-program. The fan will
automatically turn off when the internal components are cool. It
may continue cooling for 30 minutes or longer.
When "COOLINg" appears in the display window
After either using the microwave oven for a long time or using
the cooking equipment under the microwave, "COOLInG" may
appear in the display window, and the cooling fan will run until
components inside are cool. The microwave oven will continue
to operate normally.
Setting fan High/Low/Off
The Fan (Vent Fan) removes steam
and other vapors from the cooking sur-
face below the microwave oven. Press
"Fan high/Low/Off" button once for high
fan speed, twice for Low fan speed, and
press again to turn the fan off. When
you turn it on, will appear in the
display window.
Note:
The "Turbo" fan speed will run for
a few seconds even though the
"high/Low" fan setting is selected. This
is absolutely normal.
NOTE:
If Auto Off is touched after Auto Off time had been set,
you must reset the time.
Setting Auto Off 1/3/5/10
After you have selected Fan high/Low
or Super Fan/Turbo Fan On, you can
set the desired time that automatically
turns off the Fan or Super/Turbo Fan.
Press "Auto Off 1/3/5/10" button to set
fan time. The following is the set times
for the number of taps to the key:
Setting Super/Turbo/Off
use "Super/Turbo/Off" button for maxi-
mum fan speed.
Press "Super/Turbo/Off" button once to
turn on the Super Fan, twice to turn on
the Turbo Fan and press again to turn it
off. When you turn it on, will appear
in the display window.
one tap
two taps
three taps
four taps
five taps
1 min
3 min
5 min
10 min
Time Dial
Rotate
IP3696_39X00CP_Eng_25_110810:IP3677_38Q04CP_00_110608.qxd 2011-8-10 Jerry 上上16:07 Page 12
