28
Care and Cleaning of your microwave Oven
(continued)
Cleaning grease filters
The Grease Filters should be removed and cleaned often, at
least once a month.
1. Grasp the "metal ring" on the Grease Filter. Slide the
Grease Filter to the rear of oven.
2. Pull the Grease Filter out.
3. use care when cleaning the Grease Filters. Corrosive clean-
ing agents, such as lye-based oven cleaners, may damage
the Grease Filters. Clean the Grease Filters with a warm
detergent solution. Do not use ammonia or other alkali
because it will darken metal. Light brushing can be used to
remove embedded dirt. Shake and remove moisture before
replacing.
Installing grease filters
1. Slide in the edge of the Grease Filters along the opening's
guide edges.
2. Push up front edge and pull forward until it fits.
Caution:
After removing the Grease Filter, be careful with the
sharp edges at the openings.
Never operate the vent fan without the grease filters in
place.
Oven Light Replacement
be careful as the Oven Light Cover and the bulb may be
hot.
1. Unplug microwave oven or disconnect power.
2. Remove the Vent Grille and Charcoal Filter.
(see page 27 for Charcoal Filter replacement).
3. Lift the tab of Oven Light Cover, and push back. Lift up and
remove the cover.
4. Replace the old bulb with a new one.
(use 120 V, Max. 30 W)
If this bulb is not available locally, contact your local
Panasonic dealer. Part number is F60305h00AP.
5. Reinstall the Oven Light cover securely aligning the hole in
cover, onto the detent.
When cleaning the Oven Light Cover or the adjacent area,
clean with a soft damp cloth.
To avoid scratches, do not use harsh detergents or abrasives.
Grasp the ring
opening
guide
Grease Filter
detent
hole
Oven Light Cover
IP3696_39X00CP_Eng_25_110810:IP3677_38Q04CP_00_110608.qxd 2011-8-10 Jerry 上上16:07 Page 28